Bronco Sport Dash Accent Kit InstallUpdated a month ago

Step 1
Run the USB connector between the steering wheel and trim piece under the steering well until it comes out of the bottom of the trim piece. *We recommend pulling 90% of the slack in this wire through*

Step 2
Pull this trim piece away from the center of the vehicle.

Run the USB behind this trim piece, leave the excess slack from this wiring behind this trim piece, along with the small black box in the middle of the wiring.

Step 3

Clip the trim piece back into place with the USB running out of the top of this area. 

Step 4

Connect the USB to vehicles USB port.

Step 5

Tuck the black circular piece between the right hand of the steering wheel and the trim piece.

Step 6

Begin tucking the flat part of the Dash Accent wire between the trim pieces seen in the photos.

Step 7

Tuck the rest of the Dash Accent wire between the rest of the trim pieces. *the included trim tool is very helpful for this process*

Step 8

You can tuck the excess Dash Accent wire into the left side of the steering column or you can cut off the excess Dash Accent wire to the exact length you would like it.

*If you opt to cut the Dash accent wire, we recommend the cut line seen in the photo*