If your 2015+ F150 has the factory equipped LED headlights then your install of the raptor grill kit will vary only slightly. Everything is the same as the video shown below, except you will not have front marker lights to connect to like the non-LED headlamps have. (You have the lighted outline on the headlights instead.)

Instead of connecting to front marker lights as shown in the video, you will quick splice to your headlight connector on the driver side using black w/ yellow stripe for ground (typically PIN 1 or 7) and blue/grey for marker light power (typically PIN 3 or 4). Please reference the guide below for your PIN connector. ***your connector and wire options may differ than example photo shown below, please follow color guide above for your harness***

Thanks to Charles R. for providing the pic below!

To make your connection WITH OUT removing the LED headlights follow the instruction below.

Special thanks to fellow F150 owner Dennis B. for the detailed explanation below;
​
You can access the LED headlight unit's rear plug location from the left front wheel well. Remove just 3 screws, two push pins of the wheel well shroud and then the plug is accessible about one foot above your hand. Release the clip on top of the plug and bring the plug to the top of the engine compartment and make your connections to the 3rd and 7th wires. It is much easier than removing body parts and all those screws holding the LED light unit in place. Much less time and trouble!
​